When single and double wall ovens stop working the way it should, the cause usually narrows to a short list of parts and circuits. Our technicians diagnose single and double wall ovens on site, explain what is happening in plain terms, and hand you a written estimate before any repair begins. Diagnostic and travel fees, if applicable, are confirmed before the appointment and before repair approval.
What We Fix
- Bake and broil element replacement
- Convection motor and fan service
- Control-board and touchpad repair
- Door hinge, spring, and seal service
- Temperature-sensor calibration
Common Problems
- An oven that will not heat or heats slowly
- Temperature running high or low
- A self-clean cycle that fails or stays locked
- Touchpad buttons that do not respond
- A broil element that will not glow
Typical Causes
- A burned-out bake or broil element
- A failed oven temperature sensor
- A control-board relay fault interrupting the elements
- A door latch or lock motor stuck after self-clean
- A convection fan motor failure on convection models
Error & Fault Codes
A code narrows a fault to a circuit; hands-on testing tells us which part. A few you may run into:
| Code | What It Means | What We Check |
|---|---|---|
F2 / F20 | Oven over-temperature | Check the sensor and relay board |
F3 / F4 | Sensor open or shorted | Test the RTD sensor and harness |
Door lock | Latch stuck after self-clean | Inspect the lock motor and switch |
A note on safety: if you smell gas near a range or cooktop, or find standing water from a leak, switch the appliance off and book service rather than running it. We inspect the gas path and the leak source safely on site.
Brands We Service
We repair single and double wall ovens across all sixteen brands we carry, with Sub-Zero and Wolf at the center of the work:
Sub-ZeroWolfThermadorVikingMieleGaggenauBoschDacorJenn-AirKitchenAidCoveScotsmanTrue ResidentialMonogramLa CornueLiebherr
Need this repaired? Book a visit.